Page 1 of 1

the phoenix has risen, ignition switch ideas???

Posted: 10 Jul 2009, 08:54
by tezza
after having killed it last week by sticking my fingers where they shouldnt go i have found the fault, its the ignition switch, it will turn the starter but not liven up the switched live side of things .so i hot wired it (misspent youth i hear you cry!!!) and it fired up first time! question is where can i get a new switch??? preferably brand new,thanks for help tezza. :D :?: :idea: :idea

Re: the phoenix has risen, ignition switch ideas???

Posted: 10 Jul 2009, 09:03
by Red Westie
GSF (German Swedish French) loads around, the new switches cost just under £9.00.
Steering wheel off
Plastic column cowling off
Switch gear off
Sheer bolt for ingnition colar (might need to knock this around with a chisel if it is still the original bolt)
Put the key in, pull the sleaved surround off with the barrel/ingnition intact to reveal the single retaining screw.
swap
Reverse
Martin

Re: the phoenix has risen, ignition switch ideas???

Posted: 10 Jul 2009, 16:00
by tezza
thanks a lot mate i'll let you know how it goes tezza :D :D :D

Re: the phoenix has risen, ignition switch ideas???

Posted: 10 Jul 2009, 18:01
by tezza
gsf website, found part, went to their shop in swindon, had the part but they had the white switch bit which was all i wanted, followed martins instructions, 20 minutes later all fired up!!! ever fancied a job at haynes mate THANKS VERY MUCH terry :D :D :D