Club 80-90 Forums

Hello gang,

Acquired an early factory rock n roll bed which i have fitted in a late bus, the bottom mountings line up fine, but the locking pins(if i had any) are out by about a couple of inches, ie. the mounting holes are set to far back and at a slightly different height. Iintend to fabricate a bracket to get over this but not having the pins need to find out there diameter. Anybody know?

Thanx R

Perhaps you might have Rock and Roll Bed Bugs............I don't recall their ever being any pins to lock it into position.


Regards

Fritz,,,,,,,,
ps, unless you mean any pins to hold it up right when Not in use ?