Club 80-90 Forums

hello everyone can ya help me, i cant figue out how to remove the lock barrel's from the various door handles

genuine front are 1.5mm roll pin to punch out from the fork actuator
slider is 3mm grub screw just in from handle on bottom iirc
rear is 3mm roll pin to punch out from fork actuator
enjoy

i need some simpler steps i'm hopeless!! cant see 1.5mm roll pin on front handle it is genuine though

ok the bit that turns on the inside of the lock handle when you rotate the key is the actuator fork and that fits over the square shank that is the end of the lock barrel there's a roll pin through the fork and through the square shank I find a broken 1.5mm drill bit does as a drift

thanks aidan that did the trick