Club 80-90 Forums

I've just finished a partial dismantle of my Bosch Ve Pump to replace a leaky washer. Unfortunately the marks i made on the lever arm on top got erased and so I'm having trouble getting it running correctly. I can't get it to tick over(just stalls) Revs fine from partial throttle upwards to full throttle.............Any suggestions????

cant you just take the arm off and adjust it more on the splines then set the stop for the idle ?

What worries me weldore is the spline shaft that goes into the leaver arm, when I adjust it in relation to the lever arm the egine either stalls on tickover or accerlerates by it self without me touching the throttle

ooowww....well if its hunting or whatever then thats me done...i know nowt of the internal workings mate
ive got a spare 1.6 diesel pump in me shed and was gonna follow that procedure that you found a few weeks ago and dismantle it and rebuild it so i knew more about them...but...its just one of those jobs that will never get done aint it

Thanks Dave anyway, I guess it's just down to "FINE" adjustments, at least i fixed the leak Mark

someone else must know what to do

BTTT