Page 1 of 1
CV wot ave I done?
Posted: 13 Jun 2009, 09:07
by Ian and Lins
Replaced CV's on L/H side a couple of weeks ago. Had to do it myself as no time to take it to a 'proper' man. Kept everything as clean as I could; still a right heavy pain lying outside (moan over). Anyway, ...the clucking is back! Probably done about 300 to 400 miles. Any ideas pepes? Comments regarding my qualifications in bodging are perfectly accepatble and believable but I think I did everything right; ho-hum.
Re: CV wot ave I done?
Posted: 13 Jun 2009, 09:23
by jamesc76
thought this was about a job cv lol so any yay did you fill it with grease was there any play in the bearings? Oh and this should really be in technical section.
Re: CV wot ave I done?
Posted: 13 Jun 2009, 09:28
by Ian and Lins
Packed with about 100g of supplied with black grease in each joint. Old ones were knackered but replacements were new.Sorry about wrong forum but don't post very often so not too sure where to put it.
Cheers
Re: CV wot ave I done?
Posted: 14 Jun 2009, 07:38
by toomanytoys
Check to see if the bolts have come undone......... were there any "serrated" washers eith on the old bolts or with the new ones? these sould be used and clean all grease off them...