Club 80-90 Forums

Hi everyone, just about to fit 3 point belts in the back thanks to help from this forum and members. Question: does anyone know if the JK or brickwerks belts are long enough for a baby seat? The brickwerks site doesn't say how long the belt is, and any way, if it did, I'm not sure I'd know if it was going to reach from the back and go around a rear facing facing babyseat. This would be the equavalent of a Very large person sitting there..........can anyone help before I order them? I would prefer to buy the brickwerk belts as other members have recommended the quality, but if the JK ones are longer..... Cheers and enjoy the sun today! Robbie

Yes, the most recent BYard belt goes round a rear facing seat (and with some room to spare). Appears a quality bit of kit with all the additional bolts/washers etc/ and the plate to attach behind the panel. I assume Baxter has some more in then....?

Fitting straightforward for two (of the four fixing points....not three ).

The old lapbelt mounts on ours were A BUGGER to get off - had to grind them inside the van (and they are surrounded by carpet etc) - god was i nervous....watering can, fire extinguiser, hose and wet cloths all around me.......