Page 1 of 1
Build your own Rock and Roll
Posted: 09 May 2009, 22:55
by ropeman23
Sorry if this has been asked before, I did a search + looked at the Wiki, but couldn't find what I was looking for.
I have a 1986 Caravelle is it possible to convert my exsisting rear seat into a rock and roll bed? At the moment the back just folds flat on to the seat base. Can I just use a set of R+R hinges, do a few mods and turn it into a bed?
Re: Build your own Rock and Roll
Posted: 10 May 2009, 14:03
by ropeman23
Has anyone done this? Any feedback would be good.
Re: Build your own Rock and Roll
Posted: 10 May 2009, 16:01
by Grun
'ave a shuffty here,
http://www.club80-90.co.uk/pages/downloads.html" onclick="window.open(this.href);return false;
Club stuff, downloads, camping, etc.
Mike
Re: Build your own Rock and Roll
Posted: 10 May 2009, 21:13
by ropeman23
Magic, thanks Mike.
Re: Build your own Rock and Roll
Posted: 11 May 2009, 11:16
by jake1953
I'm probably dense, but does anyone have the instructions in English?
Re: Build your own Rock and Roll
Posted: 11 May 2009, 12:34
by Ian Hulley
I butchered a 2nd row Velle GL seat and mounted it on a Bluebird 3/4 RnR bed .... with a little work and a lot more thinking. Now modded slightly it's extremely comfy
Ian.
Re: Build your own Rock and Roll
Posted: 17 May 2009, 09:17
by ropeman23
Because the dims on the JK plans on the wiki are quite difficult to read I've plotted out a new plan for the cutting sizes, but I can't find anywhere to host it. So if someone has the capableities to host it somewhere I'll gladly emial them my new version.
