Club 80-90 Forums

Hi,

Me vans speedo is jumping usually worse at lower speeds 30-40 that at 60mph,any ideas for the fix of this?

Regards Dave

If the cable is frayed it may be snagging in the sheath.

new cable time?

Check the cable has no kinks or sharp bends . remove cable from back of speedo and run some oil down the inside 3in1 or something like that.

Thanks for the info I did look at wikifirst is it much of a job to change? Do you need chasis number for the correct cable or is it just model and year?I will try the famous wd40 first thought!!

Cheers Dave

76116 GSF.. all models

easy job.. follow the haynes

Cheers Kev.

there are two types of speedo cable early screw on and late push on.

Like Rob says..two types. The early screw type was only for a year or so. If you got the screw type they are difficult to get but you can use one off a bay T2

On the wheel end, If the square hole in the hub through which the cable goes has semi-rounded, you can use a flat bar or chisel from inside the cap to rework the hole and then file it square again. Otherwise its a duff cable or a loose cog in the speedo, all of which are usually repairable.

If it's clicking 3in1 should do it, if it's slipping it's normally the cap, cheap as chips from VW allegedly. If it's the inner cable just take off the circlip at the wheel and replace just the inner cable using the sheath as a guide to feed the new cable down.



Simples !