Club 80-90 Forums

i keep getting the flasher and highbeam warning failing on me i have cleaned white plug and terminals ok for a while any ideas on how to cure problem odin

Question : are you using new/used and the correct voltage bulbs/holders for this job ?

Regards

Fritz,,,,,,,,,,,,,

I take it that the high beam and flashers work but only the warning indicators are intermittent?

There is no common wiring to these and I can't think of a fault that would cause both to go 'off' other than a problem with the flexi pcb where it connects to the multiconnector under the dash housing. Try giving the multiconnector a gentle wiggle and see if it has any effect.
If you suspect that the problem is the flexi PCB best to remove the dash and inspect the edge connections (and that the Flasher LED and High Beam bulb are fitted properly in their respective sockets).