Page 1 of 1

Help needed for Sharkey!

Posted: 23 Apr 2009, 07:17
by tigsbirman
There's an oil leak but can't track it down.

Only takes a couple minutes with engine running and oil is spraying all over engine bay. All the hoses etc seem intact. Can anyone offer any suggestions as to if there is a 'usual suspect' area.

Cheers
Tigs

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 07:23
by T'Onion
Tigs
can you get a piccie up ? which side ? front ?back ?

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 07:26
by tigsbirman
Will get piccie later - Just seems to be everywhere I can't really track it down - even on outer of tailgate :shock:
Tigs

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 16:37
by tigsbirman
No Pics yet but it's puzzling.

Oil leaking into air filter, crankshaft seal, front casing.
Is the engine giving up????

Tigs

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 16:43
by Ian Hulley
Hiya Tigs, it's a 2.1 petrol/lpg isn't it ? When you say it's 'spraying' is it being thrown by the crankshaft pulley ? Is the fanbelt slipping or very shiny ? It's quite normal for oil to be in the ducting to the filter and even onto the filter itself.

It could be as simple as the crankshaft oil seal.

Ian.

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 16:46
by R0B
could be your crank shaft seal.the leak could be getting onto your pulley and this is causing it to flick everywhere.not a massive job to replace..

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 16:46
by R0B
:ok :lol:

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 16:48
by Ian Hulley
R0B wrote::ok :lol:

Slacker :lol:

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 17:32
by tigsbirman
Ian Hulley wrote:Hiya Tigs, it's a 2.1 petrol/lpg isn't it ? When you say it's 'spraying' is it being thrown by the crankshaft pulley ? Is the fanbelt slipping or very shiny ? It's quite normal for oil to be in the ducting to the filter and even onto the filter itself.

It could be as simple as the crankshaft oil seal.

Ian.



Thanks Ian and Rob

Fan belt was just replaced a couple months ago. Will check the seal - Cheers :ok

Tigs x

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 17:35
by Mocki
Tigs , wash it down, get it clean so you can see where better?

mine pithed it out of the oilfiller tube onto the zorst and was sucked up by the alternator and spat everywhere......
took ages to see where it was comming from, and about 3 mins to fix.

Re: Help needed for Sharkey!

Posted: 23 Apr 2009, 18:14
by tigsbirman
Thanks Steve - will do :ok

Cheers
Tigs x