Club 80-90 Forums

Hi,
My washer jet pipe must have come off and so when I used them yesterday the driver side worked fine but the passenger side didnt work, next minute I looked down and there was flooding around the gear stick!!
Is it a case of taking the dash out as Iv looked behind the front grill and there is no access? or can it be done with the glove box removed?
any ideas

Cheers Rich

glove box off and then reach up and there it is

Thanks mate il get to it tomorrow if the weather is any better, its been a bit rubbish for working outside

Rich-B wrote:Thanks mate il get to it tomorrow if the weather is any better, its been a bit rubbish for working outside

been rubbish all week , shout up if you get stuck and i'll nip across

now where in ere,how do you get the blighters out..ive twisted em 90 degs and still they are being stubborn !!!!

they are getting in the way of me roller chaps!!!

weldore wrote:now where in ere,how do you get the blighters out..ive twisted em 90 degs and still they are being stubborn !!!!

they are getting in the way of me roller chaps!!!

depends if your wanting to put them back in or put new ones in their place

oh,so itll boogger em if i try

not necessary , the ones i took off finished up looking like gargoyles



if you look carefully you can see the plastic lugs that hold them in place

nothings ever simple is it

looks like ,if i dont get the angle right ,itll rip the clips off...i might just roller round em.
they were tight to get out no matter where i turned em,unless i just rip em out n buy some new ones..see how mad i get tomoz with em

Thanks Mark il give you a shout if I get stuck