Page 1 of 1
Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
Posted: 17 Dec 2008, 13:48
by aussie_b
Hi all,
Trying to find out what offset (if any) is between the surface of the crankcase (where the bellhousing bolts to) to the surface of the crankshaft (flywheel side) ?
I've decided to attempt to make an adapter plate to install my diesel PUG engine because can't seem to buy one anywhere...
Any info will be much apreciated.
Cheers
Aussie_B
Re: Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
Posted: 19 Dec 2008, 19:51
by billy739
hi just seen your post.
i am having a plate made at the mo , but the plate alone is going to be 300£
doing this after 3 people have asked for one!
a flywheel costs 100£
only thing ive not sorted yet is the spigot bearing carrier.
the plate is one of phills i have as a spare which is being copied!
Re: Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
Posted: 19 Dec 2008, 21:03
by andysimpson
billy739 wrote:
the plate is one of phills i have as a spare which is being copied!
Make sure whoever copys it is pissed, it might line up properly then.
Re: Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
Posted: 19 Dec 2008, 22:06
by billy739
the plate was in a van for quite a few miles 30000 ish to be sure!
no issue's at all so no problem with alignment!
Re: Crankshaft to Crankcase Measurement - 1.9 Water Boxer ???
Posted: 20 Dec 2008, 19:26
by andysimpson
billy739 wrote:the plate was in a van for quite a few miles 30000 ish to be sure!
no issue's at all so no problem with alignment!
Not like the one i had the misfortune of coming accross then.