Club 80-90 Forums

Hello,

all the wiring is currently out of my van and thought while its out might as well give it all a clean up and check everything over but can't for the life of me figure out what this is!!

scotch locked up which i dont like for starters but dont know whether to whip it out or just make a decent job of wiring it up!!

any help would be apreciated Here's the pics that could describe more than I ever could
[img:300:400]http://2.bp.blogspot.com/_HZua_Kqd98k/S ... AG0202.jpg[/img]
[img:300:400]http://4.bp.blogspot.com/_HZua_Kqd98k/S ... AG0203.jpg[/img]
[img:300:400]http://1.bp.blogspot.com/_HZua_Kqd98k/S ... AG0204.jpg[/img]



Cheers

James

looks like some alarm/imobiliser stuff, I'd remove it if I were you as long as there's no obviously cut or rerouted wires

have traced the wires back to the indicator cables going to the stalk

could these be indicator flasher things????

there is 3 cables to each unit 1 cable connecting the pair and then two more intersecting the cable to the indicator switch

does anyone know where the indicator relay should be i nassume the fuse box????

A tip to get sharpness into those images, if i may?

If your camera hasn't got a close-focus button or setting, just try shooting from a bit further away to allow it to focus. Then even though the image is smaller, its sharp enough to be cropped down and then enlarged.

Cheers

scotch-lok-tastic

they may well flash the indicators to tell you the alarm is armed

gal,

the wiring loom is on the floor at work the van is in for paint and the engine is sat with my mechanic if i could get 2hp i'd be happy never mind 200hp!!!!

its a electromagnet reed switch, used to make the tell tale on the dash(or sometimes a buzzer sound ) flash when the trailer indecators are working.......
they are normally found in a plastic box, with a expensive name on the outside

had a good look over all the loom never had an alarm attached

the only thing i can think is its a bodge for indicators but one hell of a crap job!!! want to put back to normal if possible if i can find where its supposed to go and what supposed to make em flash

OK
have you looked in Haynes?
the relay is in the glove box

Mocki wrote:its a electromagnet reed switch, used to make the tell tale on the dash(or sometimes a buzzer sound ) flash when the trailer indecators are working.......
they are normally found in a plastic box, with a expensive name on the outside

they did come out of a pair of little plastic boxes that sounds like it may have had tow bar at one point!!!

perfect now i can remove that crap from behind my fuse box and use a good old soldering iron and heat shrink

anyone fancy a pair of these magic buzzer / flash units then cos they coming off my loom!!!!

cheers

james

Mocki wrote:its a electromagnet reed switch, used to make the tell tale on the dash(or sometimes a buzzer sound ) flash when the trailer indecators are working.......
they are normally found in a plastic box, with a expensive name on the outside

hello?????

*waves*
*jumps up and down*

cheers mocki

mystery solved and greatly appreciated