Page 1 of 1
power steeting pump
Posted: 03 Nov 2008, 19:24
by hercules
hi all well iv got a 2.1 dj ,iv just put my power steeting pump on, on one of the pip line at the end is were to put to wire on, iv look and found 2 wire that well fit on them one is white and the other black, there no other wire they to fit on form the loom are theres the right wires??, do u have the same on your pump,and info be gart
chris
Posted: 03 Nov 2008, 22:01
by syncrosimon
On mine they are yellow, and yellow and black.
All it does is raise the idle rpm a bit, if all the bits are working.
I have not looked in the book to see what colour they are on the diagram.
Posted: 03 Nov 2008, 22:07
by hercules
syncrosimon wrote:On mine they are yellow, and yellow and black.
All it does is raise the idle rpm a bit, if all the bits are working.
I have not looked in the book to see what colour they are on the diagram.
ok thanks