Page 1 of 1
tail pipe fitting
Posted: 13 Oct 2008, 16:56
by matcapp
Hi all,
I'm fitting a new tail pipe as the other has rusted off!
Has anyone any tips on how to remove the rusted plate as the bolts have no grip at all...drill?
many thanks
mat
Posted: 13 Oct 2008, 17:46
by T'Onion
just the tail pipe ? try a stud remover , aldi or lidl have them in store at the mo , very cheap so may only up to it once ,
grind the heads off and try a good pair of mole-grips on the stud , is this fails to turn them then grind them flush and drill/stud extract them out , re tap the holes and bob's at it again
Posted: 13 Oct 2008, 18:11
by hightower
If you have access to a welder you could weld a decent size nut to the tops of the rounded bolts and then you should get them moving, i'm going to have to do this to mine as could only get 1 of the 3 out when i tried.
Posted: 13 Oct 2008, 21:23
by matcapp
Many thanks, i shall let you know how i get on...
Posted: 14 Oct 2008, 16:01
by Mr Bean
matcapp wrote:Many thanks, i shall let you know how i get on...
In fact if it is the same as my WBX just cut them off flat, drill clearence holes and fit short bolts maybe with stiffnuts. No need for any more threaded holes than necessary on an exhaust system!
Cheers
Smiffy
(Germans good but not that good)
Posted: 14 Oct 2008, 18:26
by matcapp
So far so bad!
Ive managed to twist the heads off with a bolt grip...so it looks like drilling through the headless bolts and starting again...what a pain!
m