Page 1 of 1
No heat.
Posted: 06 Oct 2008, 10:17
by budbombpipe
I cant get any heat to come out my vents. I let the engine warm up nicely, switch the heater switch (the one with 1,2,3, on) and all that happens is cold air comes out the vents. I tried the sliding controls in every different position but still no heat. Anyone know why no heat? Thanks.
Posted: 06 Oct 2008, 10:25
by tonytech
Air cooled or Water cooled?????????
Could be water in the air cooling or air in the water coolinig
Or something else.
T
Posted: 06 Oct 2008, 10:32
by ermie571
Ha! Mine is the other way round....... lots of sliding but no cool.....just heat....
Mine due to the cables not actually working properly.
If you are water cooled, could be the cable aren't attached to the sliders...or the little valve in the water pipes behind the rad (i think) isn't connected to the cable, or if it is, it isn't working.
Em
x
Posted: 06 Oct 2008, 11:33
by budbombpipe
Sorry, its watercooled!!
Posted: 06 Oct 2008, 11:49
by Syncro G
Set it to hot then go through the bleading cooling system thing. Leave it on hot and go for a drive, give it time to push the air out, hopefully it'll start to warm up eventully. When its set to cold there isn't any flow through the heater so it won't unlock itself unless its on HOT (always set to hot when messing with cooling system). Also worth having a look at the heater hoses as far as you can see in engine bay/behind dash/spare wheel - If a hose is kinked it'll restrict flow.
If the leavers don't feal like they are doing something check cables.
Posted: 06 Oct 2008, 15:10
by Mr Bean
ermie571 wrote:Ha! Mine is the other way round....... lots of sliding but no cool.....just heat....
Mine due to the cables not actually working properly.
If you are water cooled, could be the cable aren't attached to the sliders...or the little valve in the water pipes behind the rad (i think) isn't connected to the cable, or if it is, it isn't working.
Em
x
Yes I had that when I replaced my fan motor. I discovered that the cable operating (or not in my case) the hot water to the heater was not adjusted properly. You need to close the valve manually and adjust the cable so it shuts the alve right off just before it runs out of push (or is it pull?)
Ken
Posted: 06 Oct 2008, 15:18
by 1664
ken simmonds wrote:ermie571 wrote:Ha! Mine is the other way round....... lots of sliding but no cool.....just heat....
Mine due to the cables not actually working properly.
If you are water cooled, could be the cable aren't attached to the sliders...or the little valve in the water pipes behind the rad (i think) isn't connected to the cable, or if it is, it isn't working.
Em
x
Yes I had that when I replaced my fan motor. I discovered that the cable operating (or not in my case) the hot water to the heater was not adjusted properly. You need to close the valve manually and adjust the cable so it shuts the alve right off just before it runs out of push (or is it pull?)
Ken
The valve wears too so that when it's fully closed it still allows water through. Not an expensive item to replace (£20ish) but a pain in the butt to do
Posted: 08 Oct 2008, 20:00
by budbombpipe
Thanks for advice everyone.
I'll have a play at the weekend.