Page 1 of 1
Oil Cooler fitting
Posted: 29 Sep 2008, 19:40
by Krisis
Ok,
I have an oil cooler and want to check on the installation of it
Any advice would be greatly appreciated
TTFN Kris
Posted: 29 Sep 2008, 20:27
by Westy.Club.Joker
see other post
Posted: 30 Sep 2008, 10:44
by dugcati
see other post
Which one? can you link to it from this one
Posted: 30 Sep 2008, 17:40
by Mr Bean
dugcati wrote:
see other post
Which one? can you link to it from this one
Yes me too!
But if anyone is interested I fitted one from Kenlow who supplied the adaptor, pipes and heat exchanger for a bit over £100. I didn't fancy piping it to the front so I cut an aperture (posh hole) next to the rear number plate and fited a couple of PC fans switched from the rad fan circuit. It put an instant stop to my randon oil light flicker and instills confidence on those big uphill drags or when at walking pace in summer jams. The pipes have swaged fittings and are tywrapped to the cross member. I could provide pictures if someone could tell me how to link my phpotobrush thingy images.
Cheers
Posted: 30 Sep 2008, 18:38
by Krisis
