Page 1 of 1
front door window trim/windscreen window trim
Posted: 21 Jul 2008, 21:27
by oldiguana
eyup ducks,half way threw a serious strip down,weld and rustoleum make over....how do i remove the window trim from the front doors to make painting easier,also is it possible to remove the windscreen without damaging the rubber or is it a cut out job and new rubber...............if so are jk or schofields the best bet...............cheers in advance
removing washers!
Posted: 21 Jul 2008, 21:47
by VWlewis
Washer jets are a one-way trip - i.e. they are fitted with expanding plastic elbows so once fitted to get them out you need to pull them slowly - you might break the elbow so you then need to change them ... BUT ... the plastic tubes they connect to will disappear behind the dashboard if you don't keep hold of them.
The tubes are often just long enough to allow you to pull them out. If you lose a tube, then it is time to remove the dashboard and re-fit them. You might even change the tubes if you get this far ... apparently good tubing is available from your local pet shop or aquarium seller. Also some people recommend using a 2 spray washer since technology has moved on since the 1980's!
Hope this helps for starters!
removing washers!
Posted: 21 Jul 2008, 22:23
by Bowton Lad
VWlewis is correct once you remove the washer nozzles thety need replacing. Best bet to remove them is to wrap a srewdriver in a cloth (to protect paintwork) & lever them out. They are very difficult to get out without a screwdriver.
Replacement washer nozzles (genuine VW) were £1.50 each from JK when I bought mine 11 months ago or go to VW.