Club 80-90 Forums

i've got a 1981 Aircooled hightop t25 and My seals between the panels are going rusty as many peoples do! i've tried sticking flowers over her but can't ignore it anymore! i spoke to a chap at diva who said wire brush them then put this stuff in them and just vacton and paint over, problemis i can't remeber what this stuff was called! i no it wasn't a bog standard filler! it was like a seam filler that i could paint over.... body sealer? Anyone got any ideas or any other suggestions?

Its not a seam sealer. Its a rust prevention chemical thats apprarrently very good. Its called Vactan. You wire brush the paint and rust off and apply this stuff and let it go off. Then you can paint over it.

Ed: Sorry I didnt read your post properly. You shouldnt need to use anything other than vactan if its at the point where no welding is necessary.

is it dinitroll..look on page 2 of the fillers section here..http://www.frost.co.uk/productList.asp...

then put this stuff in them

Kim.i was talking to a body chap this weekend........He told me the best is still the old favorite

Sickaflex......It's a damn good one hun....loads of uses