Club 80-90 Forums

I'm in the process of changing the temperature switches in my B2L and wondered if someone could tell me how to attach the switch that sits on top of the combustion chamber as it doesn't have a screw type bracket like the safety cut-out switch?
Cheers
Tony.

as far as i can remember there should be a wire clip that goes over switch
and clips under each side of switch holding it down.
did u not take it off when removing old switch?

gally

yeah as gally says.

I took the heater apart a few months ago and have only just got around to ordering the switches, looks like I'll be rummaging around my garage looking for the springy clip thing then...