Club 80-90 Forums

Are there any basics which should be followed when making stainless exhaust systems? Equal length? connectors? Cheers folks.

Stainless expands and contracts loads more than normal steel does!! Take it this is for your new engine, if so i made mine in two halfs ie one back box each side and a balance bar accross the middle (this equals up any pressure difference)

I'd be having a read of this before you get your hacksaw, tape measure and welder out.

http://www.torquecars.com/tuning/sports-exhausts.php

Regards

Fritz,,,,,,,,,,,

Yes thinking of making some systems initially for scooby. James don't suppose you have any pictures of yours. I know it's peeing with rain but when you get a minute

page 5 on here, bout best our gonna get, exh pics I got all the stuff from the firm listed on there too!!

Cheers James took me bliddy ages to read it all but v v helpful. Cheers mate.

Still not sure about exhaust length.