Page 1 of 1

2.1 water pumps

Posted: 19 Jun 2008, 20:32
by ..lee..
are gsf water pumps ok or shoulkd i buy from vw, also the 2 piece water pipe that runs under the crank pully seems obsolete where can i get one from new.



typical i only went in to change the oil pressure switch and i end up with all this.

help please as short on time.

thanks lee.


.

Posted: 19 Jun 2008, 20:34
by Laurie
GSF pumps are O.K.
THe lower hose is common to all water boxers. The steel ones are better than the plastic. Synchronuts may have some second hand.

Posted: 19 Jun 2008, 20:48
by ..lee..
thanks laurie. gsf pump it is then. would really like to use new pipes if possible but failing that i`ll try russel or cj.

thanks again lee.


.

Posted: 19 Jun 2008, 21:05
by hercules
..lee.. wrote:thanks laurie. gsf pump it is then. would really like to use new pipes if possible but failing that i`ll try russel or cj.

thanks again lee.


.
yep they ok i done mine not long ago and it was not a nice job to do nuts would not undo :cry: but got they in the end and it been good as :wink:

Posted: 19 Jun 2008, 21:28
by ..lee..
thanks hercules, stripped it all down tonight after work sod of a job to get the engine mounts off but its ready now to go back together just need the bits quickly so its ready for bvf.

lee.

Posted: 20 Jun 2008, 12:36
by mal0r
The water pipe under the crank pulley was a real bu66er to get hold of for us as gsf nor any of the bus places have them in stock due to being obsolete. I took the old one to a few engineering places, none of which would make it up for me. In the end, we got a 2nd hand one from someone breaking a T25.

If you can't source one, you might have better luck taking the old one and getting it repaired or engineered from a local pipe company. We couldn't repair ours as the hole was worn away from the inside. Good luck.

Posted: 20 Jun 2008, 18:50
by ..lee..
ok most parts sourced new now. except vw wanted £40 for a crank seal bit of shopping around and i found one for £5 . bit of a saving there vw pump was less than gsf wanted and it looks like i found the last long metal pipe in uk.

fingers crossed it all turns up right. :lol:

if it doesn`t. tent at bvf. :(

thanks all again lee.

Posted: 24 Jun 2008, 21:27
by fried chicken
Have any of you got a spare bit of rubber hose that joins the pipes behind the pulley, I need one asap.

Posted: 25 Jun 2008, 21:00
by ..lee..
you can get them from vw. i dont think there obsolete yet as they got me one no probs.

Posted: 26 Jun 2008, 11:25
by skell
it's just a short bit of straight hose that connects them, can't remember the diameter but I picked some up easily, will have a look in my garage tonight and see if there is any left over you could have