Page 1 of 1
1.9 AAZ font pulley bolt
Posted: 16 Jun 2008, 19:28
by Snag20
Getting on well with 1.6T/D to 1.9 AAZ T/D conversion.
As recommended I am changing the front crank pulley and using a new bolt.
As I have no manual what torque should I do this up ?
I think Ive read on here 60 n/m then a further 1/4 turn but cant find it now I need the info !!!
cheers
Posted: 16 Jun 2008, 20:39
by Simon Baxter
90nm + 90 degrees
Posted: 17 Jun 2008, 10:44
by Snag20
thanks Simon,
I found the original thread by Cabs---AAZ timing belt pulley-- in Alternative engine section, your post advises 60n/m then 90 degrees.
Got new pulley/bolt today should it be either 60 or 90n/m then 90 degrees-- ????
cheers
Posted: 17 Jun 2008, 18:40
by Snag20
confused or what ?
Chilton for 1.6 Stretch bolt 66 lbs then 1/2 turn
VwDiesel net 77 lbs then 1/4 turn
VW Caddy forum 90 n/m then 90 degrees
This forum either 60n/m then 90 dgrees OR 90 n/m then 90 degrees
HELP ---dont want to get it wrong ???
Also my crank pulley seems to have a layer of rubber between the inner and outer bits of the ribbed pulley for the water pump/alternator belt.
Is this normal or an anti vibration attempt by VW ???
Posted: 17 Jun 2008, 20:31
by Simon Baxter
90 plus 90, the 60 one must have been a mistake.