Page 1 of 1
ok. 12v din socket on control panel
Posted: 01 Jun 2008, 12:03
by Anonymous
The din type 12v socket on our autosleeper control panel has stopped working. Fuse is ok, there is 12v on the back of it but nothing coming out. Is it knacked?? Im assuming if there is 12v on the back then it should be fine??
Posted: 01 Jun 2008, 14:07
by kevtherev
is it grounded ok?
is the plug faulty?
Posted: 01 Jun 2008, 14:12
by Anonymous
I have put a meter on the rear connections behind the control panel and its fine. Have tried to test from the front but I dont get a reading.
Posted: 01 Jun 2008, 14:14
by kevtherev
clean the connectors mate and try again
Posted: 01 Jun 2008, 14:24
by Anonymous
will give it a bash
Thanks