Page 1 of 1

Flapping choke plate - 2L Aircooled

Posted: 16 May 2008, 22:11
by NeilC
Hi there - my first post and I'm hoping to get a bit of advice.

Attempted to start the van (1982 2L Aircooled) today after it had been resting for nearly a fortnight. It was reluctant to go, so I removed the air filter and tipped a small amount of petrol into each carb and tried starting again. This time it started fine but the choke plate in the right-hand carb was flapping around noisily and the carb appeared to be spitting. There was also a bit more smoke than normal coming from the exhaust. The sound was quite like the noisy hydraulic lifters on the wiki. Left-hand carb looked fine.

A bit concerned, I didn't leave it running for long. Checked pipes running to the carbs and they seem alright. Does the engine just need to run for a bit to calm down or should I be checking other things?

Cheers, Neil.

Posted: 17 May 2008, 08:11
by jason k
choke shouldnt be flapping about.
it sounds like the 12v choke unit is buggered but this can be replaced easily.
speak to
www.gasure.co.uk
steve is a legend on these carbs.

Posted: 17 May 2008, 09:37
by NeilC
Thanks for the reply. I've called Steve and he's very busy today but I'm hoping he's got time for a quick chat later on.