Page 1 of 1

Air cool engine removal - what next?

Posted: 12 May 2008, 20:35
by Taipan
Hi All

Just dropping the engine out of my 1980 t25 air cool. Disconnected anything I can see thats connected in the engine bay and undone the 4 engine/gearbox bolts and disconnected the bellow things. So tomorrow night I'll get my big jack under it and if I have this right i just undo the cross/support bar and then wiggle the engine out? Does that sound right or am I missing anything? :oops:

Anything I should be looking to do whilst changing the stuff over to the new (s/hand) bare engine? is it easier to check/change exhaust and heat exchangers stuff whilst its out?

Many thanks.

Posted: 12 May 2008, 21:04
by Mocki
either take your gear shift linkage off the gearbox at the knuckle, or be very carefull how far you let the gearbox drop to get the engine off, of you risk bending the linkage, and that will mean hours of fun re setting it up........ mark it before you take it off so you put it back as it was......

oh, and mind the throttle return spring bracket as you drop the engine, they have a habbit of getting wedged in the lower rear sill......

Posted: 12 May 2008, 21:05
by toomanytoys
you need to disconnct the gear linkage off the box and when lowering support the box too.. it wont stay in there.. you will need to have the vehicle up on ramps or axle stands else it wont clear under the rear...

Posted: 12 May 2008, 21:08
by Mocki
trype faster Si

hehehehe

Posted: 12 May 2008, 21:12
by toomanytoys
Frell..... I do type a lot of trype........ :shock:

Posted: 13 May 2008, 10:13
by Taipan
Thanks very much for that. I (stupidly) hadn't considered the gearbox linkage. I gather the gearbox will just pivot down as I lower the engine and I will presumably need to support it as well?

Posted: 13 May 2008, 11:05
by toomanytoys
Taipan wrote: and I will presumably need to support it as well?

Thats whats been said........ :wink:

Posted: 13 May 2008, 11:38
by Taipan
toomanytoys wrote:
Taipan wrote: and I will presumably need to support it as well?

Thats whats been said........ :wink:

Oh err yes, I see. I did read it but err was testing to see if anyone else was paying attention. Yes that's it. :oops:

Posted: 13 May 2008, 12:36
by toomanytoys
as long as you were only testing..... :lol: :lol: :lol:

Posted: 13 May 2008, 18:13
by Taipan
Ok, its out and on the dek! I just have to swap tinware etc and I may as well clean up the engine bay I think. Anyway, thanks for the advice chaps. its apprciated. :)