Club 80-90 Forums

I am swapping a 1.9td into a MAZDA RX7. I need an oil pan for the motor that is tilted over to 50*. I have a lead on a 1.6td pan. My question is will it fit and are there any differences? I assume I will need the pick up tube(if equipped) and a dip stick.


Any other help would be appreciated

thanks

lewis

it will fit, but you may not be able to attach/remove when mated to gearbox as the sump bolts need cutaways in the bellhousing(on ours at least) for access.

So worst case sceanario is I have to remove the tranny to change the pan? I am using the Mazda tranny. do you think I will still have this problem?

thanks

lewis