Page 1 of 1
Black mould in pop top roof of F reg Westie
Posted: 15 Apr 2008, 19:05
by Bluebell
Hi folks. Can any Westie owners out there recommend a way of cleaning off the black mould that forms in the pop tops of Westies? A mate has got one and is at a bit of a loss as to how to get rid of it without killing the environment.
Posted: 15 Apr 2008, 19:07
by BigTam
Just done mine at the weekend, got some caravan roof cleaner from Halfords and a good old fashioned scrubbing brush, done the trick,

Posted: 15 Apr 2008, 19:18
by Bluebell
Thanks Tom,
I'll pass that on to my mates!
Kate
Posted: 15 Apr 2008, 21:02
by lhd
Just been looking at this on Brickyard apparentl a 1/10 mix of milton is the best thing people have tried.
Dont rub to hard or you will remove the flock.
as milton is a mild bleach it will kill any mould.(apparently)
http://www.brick-yard.co.uk/forum/forum ... 17441&PN=7
Posted: 15 Apr 2008, 22:23
by BigTam
Doh ! mis-read this, thought you meant the outside, as Rob points out some info on the brickyard referrence this, where's me coat

Posted: 16 Apr 2008, 09:52
by horizontal kipper
polycell 3 in 1 mould remover and a cheap plastic scrubing brush, cheapest place i found was from wilkos. less than a fiver for both. spray it on the roof flock leave a couple of mins rub gently with the brush then wipe off with kitchen towel. dry it off with a hair dryer. mine came up like new. also did the mould patches on the pop top material.

Posted: 16 Apr 2008, 14:55
by Westy.Club.Joker
Milton mixed 10%, as stated. I used a worn one of those small sponges with the ruff green stuff on the back. Sponge the mixture onto the roof and let it work for 2 or 3 minutes, then give it a gentle scrubbing, the flock is harder wearing than you`d think. I started off too gentle, and worked up to a good scrub

Comes up like new, then use some clean water and give it a ragging off to get rid of any remaining Milton etc.
Posted: 16 Apr 2008, 15:04
by Mudlark
id read the label on the Polycell 3/1 ; think its a bit poisonous ?
I used a steam cleaner on its own; came up clean.
Posted: 16 Apr 2008, 22:35
by Other-Power
Just removing my fluff at the momment, not got time for cleaning it each time a patch of mould flares up, bit more work but worth it i think.
Jon
Posted: 19 Apr 2008, 20:26
by reddee
Mudlark wrote:id read the label on the Polycell 3/1 ; think its a bit poisonous ?
I used a steam cleaner on its own; came up clean.
Mudlark, what kind of steam-cleaner did you use/where did you get it? thanks
Posted: 20 Apr 2008, 11:09
by Mudlark
Borrowed a Karcher steam cleaner from a friend; wrapped a flannel around the brush and used as little elbow grease as was needed, no detergent or chemicals required.
Wiped down afterwards and left to dry.
You may be able to hire such a thing from a tool hire shop, but you dont need anything too industrial !
Posted: 20 Apr 2008, 19:18
by Westy.Club.Joker
It`ll come back quickly if it`s not killed off, it`s a fungus, not just a dirty mark.
Posted: 20 Apr 2008, 22:27
by Mudlark
Your right, but heres part of the marketing hype that comes with the steamer :
"Steam cleaning is the perfect answer to your cleaning dilemmas, it provides sparkling glass, mirrors and tiles effortlessly. Plus regular steam cleaning also helps destroy bacteria, salmonella, fungus and mildew and can prevent further re-infestation. "
So hopefully it will do the trick.
Posted: 21 Apr 2008, 20:53
by lhd
Just removing my fluff at the momment, not got time for cleaning it each time a patch of mould flares up, bit more work but worth it i think.
I think it has insulation properties which you would lose.
Although I have seen some with it carpeted and am thinking of this myself as one of the previous owners has rubbed of the fluff back to half way.
