Club 80-90 Forums

Hi all,
As some may be aware I am currently converting my ac bus into a scooby powered camper, right now i am fitting the heater and i have a few questions, firstly how is the temp controled, i am guessing there is some sort of cut off valve which i am missing at the mo. Also can anyone help me get one of the leavers that fits in here

[img:400:300]http://2cw65g.blu.livefilestore.com/y1p ... NY0195.JPG[/img]

Just bellow the large air hole, above the two water.

Finaly what should I do with this great big hole?

[img:400:300]http://2cw65g.blu.livefilestore.com/y1p ... NY0196.JPG[/img]

Cheers,
Jack

temp is controlled by restricting the flow of hot coolant from the engine and/or closing the vents.

big hole is for the coolant pipes, or in your cases the hot air pipe that came from the back. Ditch it and fit an eber? one less spanner in the engine fitting process

Ok so I need a flow restictor of some sort?
i know what the hole was for, just wondering if there is a plate that goes over it with the pipes coming though it?
cheers

The flow restrictor is usually found under that hole controlled by a cable from heater control sliders, its a b to get at. The hole is covered by a push fit rubber plug. If you dont cover it you will get loads of heat blowing out under the carpet wether you want it or not.

hi all, does anyone have a photo a heater in place with all pipes running into it?

It dont show much in the way of pipes but it may help.
http://archive.club8090.co.uk/viewtopic ... ght=heater

thanks bilbo blue, very helpfull. Can anyone tell me are the coolent pipes which go into the heater basicaly made up of two pipes? very long ones then 2 short ones?
Cheers,
Jack

thanks bilbo blue, very helpfull. Can anyone tell me are the coolent pipes which go into the heater basicaly made up of two pipes? very long ones then 2 short ones?
Cheers,
Jack

You can pop round and look at mine if you like.

that would be a great help, where are you again?