Club 80-90 Forums

rite i now know what alloys im gojng to fit and that i need 6mm spacers all round to bring em down to ET31.

soo i want to fit conversion studs in front and extended press in studs for the rear with open radius nuts all round.

ive seen kits on the bay for 70 inc postage but they have 10mm spacers

so where is the cheapest place to get these bits?

dan

Cheapest not always the best for the job. go to www.brickwerks.co.uk and order some from Mr Baxter, then you'll get the right stuff!

or this guy...https://club8090.co.uk/forum/viewtopic.php?t=31279

had mine off mr baxter and was spot on

just ordered all the bits i think i need off Mr baxter!