Club 80-90 Forums

15" 5 stud 195 65, would these fit my a reg t25?

Not without mods.

Audi alloys will require the centre bores taken out to 66mm. 10mm longer studs and spacers
[IMG]http://i220.photobucket.com/albums/dd17 ... G_1199.jpg[/img]

OOPS nearly forgot that a lot of messing about with centre caps. BUT WORTH IT.

Check the ET (offset) they`re not all the same

Yes Westy is right, you want 35mm OT

Or spacers to bring the ET within acceptable limits around 35mm.

Spacer size depends on ET, tyre width, rim width, suspension height and how "full" you want the arches to look.

Just fitting a set of 16" 5 spoke alloys with 205x60 tyres to my T25, have machined 30mm spacers to allow hubcaps to be retained, with longer studs all round to match, and centre bores machined out on the fronts.
Will post pic's when completed.

SCOOBYDUBBYDOO wrote:Audi alloys will require the centre bores taken out to 66mm. 10mm longer studs and spacers
[IMG]http://i220.photobucket.com/albums/dd17 ... G_1199.jpg[/img]

you mentioned the width to make the center holes bigger,but who could do that for me?

Me Long walk from Lincolshire though If you get `em couriered one-way I can sort `em for you and send `em back with our courier, at your cost obviously.

thinking of fitting some rs4's on my van but wondering wether 17 or18inch alloys would fit the best.
cheers, Mike.