Page 1 of 1
Anyone got pictures of rear seatbelts fitted into panel van?
Posted: 06 Mar 2008, 12:46
by cozmik
Anyone got pictures of rear seatbelts fitted into the back of a panel van? Internal pics of positioning and/or external pics inside of air vent or under wheel arch of plate/nut etc
churz
Cozmik
Posted: 06 Mar 2008, 14:07
by ermie571
Cozmik,
just had mine done....have loads of picture of others at home, will try and remember to host them tonight for you. You will need to know where you rear seat rests....my original bed butted up to the engine bulkhead, so rear belts were on the flat bits of the bulkhead...new seat sits further back...needed new mounts on the engine bay. All will become clear later.
then get them into a PDf for the downloads section....and/or wiki
Em
x
Posted: 07 Mar 2008, 15:22
by cozmik
Great, thanks a lot Em. I'm doing a similar bed moving job and not quite sure exactly where to place the support plates. Ideally I'd like to put two three points and a lap belt in the middle of my full width bed.
Cheers
Coz
Posted: 07 Mar 2008, 16:14
by ermie571
coz,
where is the bed going....is the seat base when its a seat, butting up to the slopey bulkhead, or is it further back, resting on the engine bay?
this will effect where you put your belts! Don't panic, though, I have pictures for both!
Em
Posted: 07 Mar 2008, 16:56
by Pepperami
I think there is a good picture in the JK catalogue.
Posted: 08 Mar 2008, 20:11
by cozmik
I havent seen the JK catalogue, didnt get one!
The seat sits on the slope Em, on the D shaped underneath bits (excuse technical terminology
)
Posted: 08 Mar 2008, 20:33
by ermie571
Cozmik...did the link in the pm work?
I think for the three point belts, you would have 2 of the fixings on the side wall...one behind the very rear window, amd one at the bottom of the wheel arch. But not sure, as that is not the set-up I have - I have put in the automhomes bed which sits further back.
Hubby has got the full width rnr in a panle, but we haven't put belts in yet.
Em
Posted: 08 Mar 2008, 21:44
by Ray
cozmic if you pm your e mail a/d to me I will post you pictures of the welded plates that I did on my panel van. I got a set of three velle rear seat belts from a show and put them in last summer. I can,t post on here cos dont know how.
Posted: 12 Mar 2008, 23:09
by cozmik
Yeh it worked thanks Em, I PM'd you. Thanks again for all the pics & advice, I'll let you know how it goes.