Club 80-90 Forums

Hi All. Just wanted to be clear on a couple of points.

I've got a 2.1 DJ 1990 caravelle. Which seems a little flat.

Now are there two Temp senders? One to the dash gauge & one for the engine management? By wiggling wires managed to get the dash one working again. Anyway of checking the management one?

My haynes doesn't make it clear (to me anyhow). And JKampers don't fill with confidence

Anyone know VW part numbers?

Cheers m' dears!

KarlT

Apart from Haynes 'Sensor test Data' (Page 4B.1 in my book) which reads,

Coolant temperature sensor resistance
At 50 degrees C approx 800 ohms
At 75 degrees C approx 350 ohms
At 100 degrees C approx 200 ohms

Readings which you could get with a multimeter, and a thermometer, (or at least check with engine coolant cold and hot) substitution of a known good sensor (sender) would seem to be the only way, assuming wiring, contacts, etc. are OK.
Can't help with part numbers but no doubt someone will be along who can.


Mike

These are the Dj senders Etos isnt entirely clear which is for what but I include all the detail here for you heres the link to www.vagcat.com where you can see the misleading diagram for your self!
http://www.vagcat.com/epc/cat/vw/T2/1989/78/57/892227/ you may need to login user: club8090 pass: letmein


025 906 041 temperature sensor 2 pin blue M12X1,5 26,65 GBP
N 013 812 8 seal 0,21 GBP


025 906 041 A temperature sensor thermostat housing 2 pin 3,6mm blue 20mm 12,52 GBP
032 121 142 retaining spring 0,38 GBP
N 903 168 02 round seal 0,86 GBP


251 919 501 D temperature sender for coolant temperature gauge 2 pin green black 20mm 18,09 GBP
032 121 142 retaining spring 0,38 GBP
N 903 168 02 round seal 0,86 GBP

Thanks for taking the time Bob & Grun, but that makes no sense at all to me!

I might just have to take a lucky dip!!