Club 80-90 Forums

where's it all fixed to ? got the bracket on the door pillar, the big bolt through the floor in the cupboard, anywhere else ? It's reluctant to get loose

All over the place dude. I took mine out of a califoinia big bolt in bottom self tapper behind drivers seat captive bolts in cupboards on left of fridge lots of wires marked with masking tape to where they go. It sounds bad but it was much easer than i was thinking and when i put it all back it all worked.

All over the place dude. I took mine out of a califoinia big bolt in bottom self tapper behind drivers seat captive bolts in cupboards on left of fridge lots of wires marked with masking tape to where they go. It sounds bad but it was much easer than i was thinking and when i put it all back it all worked.

Sorry i said that twice. Thinking about it some of the fixings are on the swivel table supports hope this helps Simon

cheers. finally got it all out, only to reveal my greatest fears, it's rusty everywhere behind

Hope it's not this bad.......

http://www.rustbuster.nl/Bus_zijpaneel/index1.htm

I own an 83 westy and Idont want to look behind there.....
good luck,lhd.........

lhd wrote:Hope it's not this bad.......

http://www.rustbuster.nl/Bus_zijpaneel/index1.htm

I own an 83 westy and Idont want to look behind there.....
good luck,lhd.........

it's worse
look behind there before the rust really takes hold

Yea sounds the same as mine about 10mm gap on side of van and a bit of floor missing. I had mine fixed by a garage cost £250. They did a great job i am really pleased with it. So get it done it will be not as bad as you think.