Page 1 of 1
?replacing indicator bulb holder how to please????
Posted: 08 Feb 2008, 09:37
by joebrown
i have checked the wiki but to no avail please may i have a step by step to changing the loom as my one has mysteriously collected water in bulb holder and rusted and one of the contacts inside holder broken off,thank you in advance for any replys.regards joe
Posted: 08 Feb 2008, 09:55
by Titus A Duxass
Are we talking front or rear indicators?
Posted: 08 Feb 2008, 12:06
by toomanytoys
presume front...
Undo 2 scres, remove lens, undo bulb holder, disconnect from loom, (if no connector present then you will have to cut the wires) get "new" holder either solder the new wires to the old and insulate or reconect or crimp connect.. refit bulb holder in lens, refit lens put screws in and do up....
Posted: 09 Feb 2008, 07:32
by joebrown
sorry front indicators please advise