Page 1 of 1
Centre Trim/Console - Removal
Posted: 05 Feb 2008, 09:15
by Titus A Duxass
How do I remove the plastic trim/console that sits in the middle under the dash?
I want to fit a new carpet and can't work out how to get the thing out.
Also, has anyone carpeted their bus using low-cost cord type carpet? If so how did you get with the Driver/Passenger area (i.e with regard to the shape/tunnel etc)?
Thanks
Titus
Posted: 05 Feb 2008, 10:22
by ermie571
Titus...if you mean the one that sits behind the gear stick and goes up to the dash, and feeds warm air to the cab....then mine just slides in and out. It can be a bit sticky, especially if someone had issues with it keeping sliding out and put sommat sticky in it to hold it in.....
pulls out straight and level towards you. IIRC there are four runners to line up when putting it back....two full length ones at each edge, and shorter ones in the middle.
If you are still stuck this afternoon, I will take a picture of mine that now comes out real easy!
Em
x
Posted: 05 Feb 2008, 11:25
by Titus A Duxass
yep, that the bugger.
Mine is stuck or appears to be.
Further investigation needed.
Photos would be useful.
Ta
Posted: 05 Feb 2008, 11:44
by ermie571
ok - will see what I can do!
if it has gone in on the "wrong" runners I would have thought it would have cracked?
Anyways...if you can wait till later....photos will be added
Em
Posted: 05 Feb 2008, 12:17
by Titus A Duxass
yes, later is no problem.
I am off sick and it is piddling down at 4c so am not going out.
Posted: 05 Feb 2008, 16:00
by Aidan
there are tabs on the end of the fixing rails which click behind the heater, you need to gently pull them outwards to disengage before pulling the whole backwards, if loose like your mans then somebody has previously employed brute strength and ignorance method.
Posted: 05 Feb 2008, 16:18
by ermie571
There you go....someone with proper knowledge.......mine must be missing the catches!
Taa Beaker!
Emma
[img:400:300]
http://img4011.photobox.co.uk/51207369a ... ed8b87.jpg[/img]
the red ring shows the cath which is present and correct. If you copy and paste the picture into paint, you will see that the plastic is shaped like a small triangle with a notche that locates behind the duct.
the slide rails on the heater ducts:
[img:400:300]
http://img4011.photobox.co.uk/899188886 ... 2890fe.jpg[/img]
To get mine off I have to hold it each side, where I can get my fingers round it, and give it a bit of a wiggle and tug....sometimes it comes out easier one side first. then to put it back, Ilocate it and puch in....and small thump (gently) locks it into position.
Em
x
