Club 80-90 Forums

T25-1986-DG 1915 watercooled. Im getting a couple of corroded brake pipes replaced soon and noticed on the rear 4 way junction (front to back, left & right pipes) theres a small bore metal pipe going up from the junction and into the rear of the engine compartment somewhere. Not had a chance to have a good look yet but does anyone know what this pipe is? This pipe is a smaller diameter the the standard metal brake pipe.
Thanks

this is probably the fuel pipe! there is a mont on the 3 way splitter screw!
sometimnes its just cut and left if th fuel pipe has ben replacd, should be blac plastic from factory! cheers

billy739 wrote:this is probably the fuel pipe! there is a mont on the 3 way splitter screw!
sometimnes its just cut and left if th fuel pipe has ben replacd, should be blac plastic from factory! cheers

Thanks Billy but i dont think its a fuel pipe, its a very small bore, smaller than a standard metal brake pipe and most fuel supply pipes are usually slightly larger than brake pipes?
Will have a look at the weekend..

billy739 wrote:this is probably the fuel pipe! there is a mont on the 3 way splitter screw!
sometimnes its just cut and left if th fuel pipe has ben replacd, should be blac plastic from factory! cheers

Had a look today and saw the fuel pipe attached to the 3 way splitter you mentioned billy. also realised on closer inspection that the 'pipe' i was looking at was in fact not a pipe but a thick wire holding in place what looks like a bulkhead sound proof panel !!!