Club 80-90 Forums

Can anyone tell me what the centre bore should be in order for alloys to fit a T25?

Cheers

G60steve wrote

Centre bore 57.1mm so 2 wheels will need the centre bore machining out to approx 66mm to clear the front grease cap.

found using the search facility

hope this helps

could maybe fit the grease cap after the alloy if its close. maybe save a couple of mm?

Merc 15" AMG wheels - will the centre bore be adequate - can't quite tell from the Wiki?

Can't you measure it?

or get some one to

Haven't got them yet Just want to know that I'm not wasting my money .....(again)

that's good sense mate..if you have no joy here try Brickyard

I've serched but can only come up with steels

Cheers Kev

Has anyone had any experience of fitting these wheels:

[IMG:400:300]http://i121.photobucket.com/albums/o211 ... rs/amg.jpg[/img]

15" 5x112, 7J, ET 35

Merc centres are usually OK as they are machined big from the factory

All the sizes look good, offset is spot-on etc. Probably have to drill the stud holes out slightly, Merc uses smaller diameter (but only a small amount)

You will need longer rear stud kit, and either a front stud conversion kit (best way to do it) or longer front bolts.

All parts available from Baxter

Wheels bought:

[IMG:800:594]http://i121.photobucket.com/albums/o211 ... g_0217.jpg[/img]

Guy described them as 'good condition' - yeh right!. Spent all morning refurbing them

Am I right in thinking that the stud/bolt holes are 12mm on Merc wheels?

Yes they are, they need drilling out to 14mm