Page 1 of 1
Oil Temperature Sender size
Posted: 06 Nov 2007, 21:34
by slobbo
I have purchased a sender and gauge but the sender doesn't fit in the hole. The sender bottoms out before the thread takes. I have been told it's 1/4 inch with a 1mm thread but I can't find anywhere that sells this size. What is the size I should I be getting? I have seen adaptors and senders but don't know what one to get. Any ideas? It's an AAZ I have.
Posted: 08 Nov 2007, 15:29
by mcgill5
in my vast experience! if it doesnt fit there are a number of reasons; 1. you arent shoving hard enough! 2. its cured of epilepsy! 3. its too big!
cheers,the oracle mcgill
Posted: 08 Nov 2007, 16:03
by mcgill5
in my vast experience! if it doesnt fit there are a number of reasons; 1. you arent shoving hard enough! 2. its cured of epilepsy! 3. its too big!
cheers,the oracle mcgill
Posted: 08 Nov 2007, 21:12
by Westy.Club.Joker
Senders in original engine are 10mm x 1mm thread pitch. If you have got an aftermarket sender for a gauge or similar it will probably be 1/8 BSP, so you`lkl need an adapter to sort the problem. Try Baxter at his garage he sells various adapters, t-pieces and gauges etc to do this sort of thing