Club 80-90 Forums

Hi there, recently bought a T25 Kameo and gauges have been working fine. We fixed the water pump on it (with much help from this site!!) at the weekend. Took it out for a drive last night and noticed that neither the fuel gauge or the temp gauge is reading anything at all. Filled up with petrol and still nothing. Have read previous posts about dodgy fuel gauges but none seem to be the prob we have. Could it be something we did at weekend? Am guessing its not a prob in fuel tank cos temp not working either. Anything i can do to sort it out or is it new clock time?

Thanks in advance

Sam

check the earths in the engine bay, brown wires........

take the plug off the temp sender and join the two connections in the plug together, the gauge should go to the eversobloodyhot end.
if not, its a fault either in the wires, or the multiplug at the dash end, which you can wiggle by putting your hand up the dash above your right knee when sitting in the driving seat..........

go for multiplug first, pul off and make contacts all shiny with a green scouring pad.

Check the tracks on the blue printed circuit board from the instrument panel, I had this problem, replaced the printed circuit, bought from VW for £65.00,

Thanks for the tips guys. Had a good look today. Turned out that the black clip that the multiplug goes into was broken so it had jigged itself loose and thats why it wasnt working!! Done abit of a bodge on it with some cable ties and it works a treat now! Really glad it wasn't something horrid!

Thanks again, so glad i've found this site you are so helpful, hopefuuly i can return the favour when i know some more!!

Seeing you at a club meet will be thanks enough for those that helped

Hi there

Just hop onto this topic if I may because I have a similar problem. The fuel gauge works but not the temp guage although the red light flashes when the ignition is turned on.

Things I have tried:

Diff instrument panel but temp gauge still doesn't work
Cleaned multiplug
Wired the two terminals on the wire that fits onto the temp sender but that doesn't have any effect and doesn't send the temp guage to hot

Does anyone have any other ideas

Thanks