Page 1 of 1
T25 rear metal brake pipe
Posted: 26 Aug 2007, 23:54
by nesty
Hi
My rear metal brake pipe snapped whilst I was doing a rear cylinder change.
Anybody know where I can get a replacement. Just Kampers don't do them?
Nesty
Posted: 27 Aug 2007, 06:58
by SyncroSam
Take the old pipe to a good motor factors and they will make you up a new one.
Cheers,
Sam.
Posted: 27 Aug 2007, 09:26
by nesty
ok cheers
Nesty
Posted: 27 Aug 2007, 09:45
by oldiguana
y dust get thee sen a flarin tool(about £20-roll of pipe £6,brake ends 50p each),n you can make your own for pennies and always good for when you snap a pipe on a sunday night-when all the shops are shut...it always happens on bank holidays also...............regards
Posted: 27 Aug 2007, 09:51
by nesty
Hi
Do you have any link on ebay to any decent ones?
Nesty
Posted: 27 Aug 2007, 10:46
by CovKid
To be honest, a set of pipes from GSF is cheap enough - hardly worth the bother and you then have a few spares to hand.
I fitted copper pipes all round the day I got my bus as I hate messing with corroded pipes and it made sense to sort the lot first time. Cost around £50 though.
Posted: 27 Aug 2007, 12:35
by nesty
Do GSF do these? I couldn't see them listed on the website?
Posted: 27 Aug 2007, 19:10
by syncroand101
£50? Do you mean the flexi section?
Copper bits normally cost about £2-3 each for the short bits!
Posted: 27 Aug 2007, 19:25
by CovKid
£50 yes - for a full set including all the long ones, cross pieces, up to the master cylinder etc. Took over a day to do the lot. No GSF don't do them.
They were mail order only I think.