gearbox/driveshaft advice please
Posted: 22 Jul 2007, 20:45
running home today and i started to get a knocking noise from underneath, obviously panic ensued! it was making a noise when the clutch was let out so i guessed gearbox.
limped home by which time the noise had stopped and got the back end up. i span the wheel either side and they span fine no horrible noises. i then ran it with the engine and found that the n/s wheel ran round fine with no drama, increased revs and sped up perfectly.
the o/s wheel was different. it didnt spin just on tick over like the other side, started to move when revs increased but was a bit 'jerky' but no noise.
i tried a little experiment, i put my toe onto the bottom of the tyre when it was on tickover. the n/s wheel nearly put me on my a*** and it made no difference but the o/s wheel stopped dead and i was even able to rotate it the other way!
so i'm thinking driveshaft in some way is toast but what is at fault? is the the cv joint or is it the box itself? or is it something else.
i dont want to replace the box if all i need to do is replace the cv joint or something else.
any advise please, ta
limped home by which time the noise had stopped and got the back end up. i span the wheel either side and they span fine no horrible noises. i then ran it with the engine and found that the n/s wheel ran round fine with no drama, increased revs and sped up perfectly.
the o/s wheel was different. it didnt spin just on tick over like the other side, started to move when revs increased but was a bit 'jerky' but no noise.
i tried a little experiment, i put my toe onto the bottom of the tyre when it was on tickover. the n/s wheel nearly put me on my a*** and it made no difference but the o/s wheel stopped dead and i was even able to rotate it the other way!
so i'm thinking driveshaft in some way is toast but what is at fault? is the the cv joint or is it the box itself? or is it something else.
i dont want to replace the box if all i need to do is replace the cv joint or something else.
any advise please, ta