Club 80-90 Forums

My Westy has a 1.9Tdi AFN engine in. It was once a 1.6 TD JX.

Etka shows the JX back pipe runs from the Muffler to the Turbo.

However there is another 'piece' on my 1.9 between the Turbo and the back pipe which has split.

It appears corrugated steel. I can only think hat it is needed because the turbo on the AFN sits further back than on a JX and it bridges the gap ?

Anyone know the ID of this part? Part number if its VW or any other info will be of great help.

Thanks

Mark

Further forward on the vehicle Mark?

Do you mean flexi-hose, as in a stainless-steel concertina style exhaust section?

If so I imagine it was welded in to take account of slight difference in length or difference in height of the Tdi turbo (if there is) AND/OR just as a precaution against vibration...

My custom s/s TD exhaust made up by AndyS has a length of such flexi, just after the 180 curve around to face the back...

Equivalent to this...

[img:289:385]http://www.dynoflow.co.uk/_wp_generated/wpe38a1bd4.jpg[/img]

Could be wrong but would think you need some fabrication doing...

Sounds like a special to me unless the turbo is mounted on a jx manifold. If its a tdi manifold turbo will be much higher. I could sort you one if it uses jx bits but not a tdi turbo and manifold.

Its a JX pipe to an AFN turbo/manifold.

I think I have come up with a local solution reusing the old flanges.

Fabricator could not understand why it had to be flexi; nor did i; but thats what Im going for.

So looks sorted now, but thanks for the info.

Mark if it is not flexable and u catch ure tail pipe offroading all the stress gets put onto the rubber mounts and breaks them.And at almost £10 each, when u go through as many as myself that can become expensive.

The part is a flexi, so it should be as it was. Im having the old flanges tig welded on.

Its a bit of a drag; as the garage is the opposite side of town to the exhaust fabricator.

I collected the old joint from the garage on friday and delivered it to the fabricators.

This morning i collected two cut flanges and the new flexi and delivered it back to the garage; he has to fit flanges, put joint in position and spot weld it all together.

Then i have to pick it up and take it back to the tig welder to finish and take it on back to the garage for final fitting.

26 mile round trip x 4

Fingers crossed we will still be heading off on holiday in two weeks

Mudlark wrote:26 mile round trip x 4

Sounds exhausting...

Could easily be MIG'd, whether stainless or mild steel, but TIG better of course...

Have been using stainless MIG wire a lot lately... not always exhausting either