Page 1 of 1
indicators
Posted: 10 Jul 2007, 19:54
by davos
My van failed the MOT today on the indicators flashing more than a 120 times a minute, in other words they are going like mad,
All the bulbs are working and flashing, - any idea what could be causing it?
I have checked the wires for rust and can't spot anything up with the lights
Thanks
Dave
Posted: 10 Jul 2007, 20:52
by geordie skydiver
Earth fault.
Posted: 10 Jul 2007, 20:54
by kevtherev
yes I think so too
Posted: 10 Jul 2007, 21:11
by davos
geordie skydiver wrote:Earth fault.
thanks- what should I be looking for?
Posted: 10 Jul 2007, 21:25
by geordie skydiver
Locate the earthing block that is relevant to the indicators (there'll be a couple) and clean up reconnect each terminal in turn.
Make sure each indicator bulb is nice and clean (the metal bit) not green and furry,and the electrical connectors are ok.
Haynes manual should tell you where the earthing blocks are.
Posted: 10 Jul 2007, 21:57
by phade
Wrong relay indicator installed ?
Do the indicators (eg. the number of them) work correctly apart from the flash rate? If that is the case then all you have to do is to get a standard 12V beetle indicator relay since they are indentical to the correct ones for the type 2 T3.
My campervan had the wrong indicator relay installed on it (the relay it has was for type 2 T3 emergency vehicles - eg. ambulances).
Posted: 11 Jul 2007, 06:49
by Mocki
you can slow them down to get it thro by adding more load . add a extra bulb to each side - not a cure but a way out ?
posted mobile via t-mobile
Posted: 11 Jul 2007, 19:21
by phade
This sound very much like it doesn't have the correct indicator relay (eg. it has got an indicator relay which is only suitable for emergency vehicles - eg. ambulance, police, etc).
I tried adding an extra load to my indicators in an effort to slow them down, but to be honest when I tried my Beetle's indicator relay (and double checked it with ETKA) it turned out that the Beetle's indicator relay is the correct one for a standard Type 2 T3.
The correct indicator relay its self fits all Beetles (Type 1) from August 1967, all Type 2 T2s and Type 2 T3s (up to 1991). I am however not entirely certain about the south african Type 2 T3s (up to 2003).
Posted: 11 Jul 2007, 19:27
by davos
will try and get new relay before weekend and give that a go will let you know how it turns out many thanks for help dave
Posted: 14 Jul 2007, 09:42
by davos
thanks phade you were right put new relay in now they flash at right speed
well pleased thanks dave