Club 80-90 Forums

Did I see someone on 8090 selling rear lamp guards? Was it Firetruck?

think it was fritz

twas the fritzer. here is a set on my bus

http://www.freewebs.com/ababyonboard/thevanitsself.htm

jed

i got some on the shelf if needed.

251/2 only aren't they ?

253, 254, 255 and 256.

Pickup/Doka ones under development Andy!!!

I reckon they'd be neater if they fixed behind the lens clusters, using the same fixings, like the ones on Holloways velle.

On the subject of butch accessories, do any UK traders list rock-sliders (to protect my precious locker doors and sills), or should I be approaching someone for a bespoke set ?

I have been thinking of making some similar to ones I made years ago for an old Range Rover. Essential a length of heavy tube (50mm OD 3mm wall?) with the ends plated over & smaller tubes welded through it to insert into the two jacking points. I am sure a bolt fitting of some sort can be made to hold them in.

A second set of short cross tubes could be built in to allow the use of the original jack.

Get the whole lot galvanised for protection and painted if you like.

Garyd

Andy i can make u a set but i dont like the idea of them going through ure old jaking points.
If u want i will discuss with u at SP.
Russel

Hi Russ,

You were first on my list of people to contact ! I'll give you a bell...

Cheers,

Andy

Not UK but a selection here to browse -
http://stores.ebay.co.uk/HEST-Edelstahl ... esstQQtZkm