Page 1 of 1

removing sliding side-windows and rubbers.

Posted: 03 Jun 2007, 14:05
by wasserleaker
howdoo all,
need to look at removing these this summer to sort out some corrosion problems, rust bubbles below bottom edge of side windows, [no doubt worse than it looks when they're out]
any tips on removing these from anyone who's done it?
once the locking/trim strip is out do they come out fairly easily?
will most likely need to put new rubbers in after any welding repairs are done if necess.
thinking of getting the JK bundle pack of every rubber on the van, as the screen is a bit leaky too. when they say 'no trim' in the JK catalogue, do they mean you'll need to re-use your trim, or are the rubbers solid like the old cal look beetle replacement rubbers with no trim strip?
cheers muchly for any help! :)

Posted: 03 Jun 2007, 15:55
by kevtherev
I have found VW shows a valuable source of rubbers, felts and seals. (particularly vanfest)

as for the windows then yes it practically falls out once the locking strips have been removed

I think it's a two person jobby though...start with a corner.

I didn't fit new ones as they were still serviceable

Posted: 03 Jun 2007, 21:33
by wasserleaker
thanks Kev, will hang on a bit and wait till vanfest then, i think.

Posted: 03 Jun 2007, 22:44
by Willoughby
Hi

I am looking at getting a full set of rubbers for my bus and have been told JK rubbers are not up to much.
"Status VW" and OEM look to be the best but they are pricy. NER are said to be the best if you don't have status money.

If anyone has used NER can you let us know what they think?

http://www.status-vw.co.uk/

http://www.northeasternrubber.com/

Kev

Posted: 04 Jun 2007, 21:08
by wasserleaker
think i've seen Status before at vanfest, and they sell some genuine VW seals and window rubbers, forgot about them, willoughby, thanks :)

Posted: 04 Jun 2007, 22:33
by oldiguana
jesus christ,arv jus lewked on the status sight n nearly had a connery!!!!,ar conna affowd them prayces,i think ar mayt be able ta afford the seals from n.e.r....does anybody know which rubber i would need for marladys van,its a holdsworth villa 1983 and has the non genuine windows which sit proud of the body????????..................

Posted: 05 Jun 2007, 16:10
by Willoughby
Hi oldiguana

Thats what I thought. The guys a NER know there stuff give them a call. I am going to send them down a 2" bit just to confirm I get the correct profile.

Kev

Posted: 05 Jun 2007, 17:40
by maximus

Posted: 05 Jun 2007, 21:42
by oldiguana
ah duck,i looked on schofields but they only do rubbers for genuine vw windows dont they?,the ones which are plush with the bodywork.......from caravelles etc.............i cant afford the silly prices.......and so it continues!