Page 1 of 1
Rocker Cover Gaskets
Posted: 28 May 2007, 09:59
by Dubstar
Just about to attempt to change the rocker gaskets on my 1981 Aircooled-which way do I move the big rocker cover clip, up or down? And do I have to remove anything else to do the change-ie exhaust? Thanks.
Posted: 28 May 2007, 19:30
by west E
You need to move it down, use the biggest flat blade screw driver you have, it will help you lever. when replacing you gaskets use some blue seal to help keep the new gasket in place.
cheers
ian
Posted: 29 May 2007, 16:25
by jason k
i always find its best to leave em settle overnight too. stops leaks as they set nice!!!
Posted: 29 May 2007, 17:08
by smithybluebus
if you aint got blue stuff grease does the same i found too on all my Aircooled enigines
Posted: 29 May 2007, 21:50
by Dubstar
Cheers for all the replys guys. After trapping my fingers behind the spring clip for about five minutes I went in and got my crowbar on it, and it came off a treat. Cleaned it all up as someone had used a setting type gasket goo on it in the past, and stuck a nice new cork gasket on. Didn't use any grease or blue hylomar but hopefully it's all sealed.