Page 1 of 1
BAD RUST AROUND WHEEL ARCH HOW DO I REPLACE PANEL PLEASE
Posted: 13 May 2007, 15:35
by joebrown
(have checked with wiki although helpful and nearly sent me off on a tangent doing other stuff could not help) it has just failed its mot due to a lot of rust around drivers side rear wheel arch if anyone knows of a step by step photo gallery guide that would be bloody marvellous.
I want to replace the panel and then on to a respray any advice ,comments,thoughts and donations gratefully recieved as allways thank you in advance and as allways i will let you know the outcome through this post.thanks bruv
Posted: 13 May 2007, 16:06
by kevtherev
so you want to do this panel replacement yourself?
Posted: 13 May 2007, 16:26
by joebrown
yes kev i have the time to give it a go and the neighbour with the gear.Do you think this is something that should only be handled by a experienced person I am very much undecided on that question myself therefore any wisdom you can share with me kev would be gratefully recieved mate
Posted: 13 May 2007, 16:43
by kevtherev
Have you got the panel yet?
Posted: 13 May 2007, 16:55
by mrwood
Hiya,
Some info regarding arches on the below link, I asked a similar question a while ago
https://club8090.co.uk/forum/viewtopic.p ... highlight=
Hope it helps
Posted: 13 May 2007, 18:32
by joebrown
no i have not got the panel yet however i will be getting a schofield panel as a little dicky bird tells me they are better than the jk panels kev.
Posted: 13 May 2007, 18:48
by kevtherev
get the panel as then you can see what has to be removed.
practice welding on it
Posted: 13 May 2007, 21:23
by hakuna matata
Posted: 14 May 2007, 15:32
by patrick norway
how much do you pay for a replacement panel?
Posted: 16 May 2007, 10:59
by joebrown
there appears to be a few suppliers of differing quality and price,the top price being about £45ish.
Posted: 16 May 2007, 20:27
by kevtherev
schofields quality is good...
