studs
Posted: 19 Dec 2005, 17:33
after reading a posting by ashman about leaks on a dg engine.does any one know,if the studs snap when you take the cylinder head off is it defo a new engine or can you get the studs out and replace them 
Page 1 of 1
Posted: 19 Dec 2005, 17:43
all depends on where the stud/s snaps
Posted: 19 Dec 2005, 18:31
I think they can be drilled out and replaced, surely someone manufactures aftermarket stainless ones?
Posted: 19 Dec 2005, 21:05
yo can get the studs out sometimes easily some time not so. some reckon it's and engine out job it it/they snap but ive seen them done in situ!!
Posted: 19 Dec 2005, 22:24
djb,i knew i should have changed the subject title 