Club 80-90 Forums

Any tips on fitting the sliding door seal on a t25?

I don't really want to take the door off, so it means cutting the seal at some point. Where's the best place to make the cut - I suspect at the bottom somewhere? What type of glue should I use? Any tips generally?

Thanks in advance!

Dave Jones

the glue to use is bostik.the tin with the brush in it.just pull the old one off.don't bother cutting it.you will be replacing it anyway....

Thanks for the info re. the glue.

I meant that I will have to cut the NEW seal (which is one continuous loop at the moment) at some point, as I don't want to take the door off.

I suspect I should cut the new seal at the bottom - any advice?

Dave

sorry i misread you.i would cut it at the bottom as well.

I suspect I should cut the new seal at the bottom

Hi Dave,
Not certain that it would work, but why not just pop the rear of the door off, and slide the seal over? I imagine this would work, but can't say from experience. Best of luck!

Myk.

All you need to do is undo the bottom hinge and slip it over then bolt the hinge back up.

Thanks for all the advice - much appreciated!

Dave